![]() Then I've decided using the same configuration to add static ip address to rPi's usb0 interface and dnsmasq for dhcp server with the idea to set dhcp client on the lte interface on RouterOS side, but I hit another wall - now the lte interface is gone, RouterOS still detects it in /system resource usb. I've configured the rPi to use cdc_ecm using g_multi and configfs and there you go - RouterOS detected it as LTE interface, but sadly there is not much you can do with it since it's not actual LTE. Reading about RouterOS usb support I've decided to change the configuration a little bit using g_multi and configfs(linux virtual filesystem used to configure g_multi and others alike). When connected to RB using the same g_ether module it only shows it in the /system resource usb again as RNDIS/Ethernet Gadget. When using g_ether and when connected to PC, the PC detects it as RNDIS/Ethernet Gadget and you can assign address, share internet connection to it and so on. The rPi uses dwc2 overlay to control the otg/host functionality and g_ether for the usb interface communication, there are other possibilities as well like g_serial and g_multi. ![]() The mini computer (rPi) has only one micro usb interface connected directly to it's cpu which gives the possibility to configure it as usb host/otg. There’s also a full-size, Gigabit Ethernet. Differences between different levels of license, we recommend you take a look. The right side has four USB Type-A connections, two of which are USB 3.0. The license key for your installed RouterOS on RouterBOARD or x86 platform. Recently I've tried to connect Raspberry Pi Zero to my RB962UiGS (hap ac). The Raspberry Pi 4 covers more than just the basics when it comes to ports.
0 Comments
Leave a Reply. |